911 Carrera Cabriolet (997) F6-3.6L (2007)
^
1 - Crowfoot wrench a/f 19 NR.11-1 (snap-on).
^
2 - Extension 3/8-inch, 16° moveable NR.15.
1. Remove both cable plugs in engine compartment (cylinder head cover, side 4-6).
2. Remove cover plate for ignition coils. Unscrew two M6 Torx screws and remove plate.
Note: The sender is removed from and fitted onto the underside of the engine, therefore the direction of rotation must be observed.
^
Undo: in a clockwise direction.
^
Tighten: in an anticlockwise direction.
3. Remove oil-pressure sender with Extension 3/8-inch, 16° moveable NR.15 and a crowfoot wrench a/f 19 NR.11-1 -1-. Use a long, 3/8-inch
extension -2- also.
Installing oil-pressure sender
Installing oil-pressure sender
1. Position oil-pressure sender with new sealing ring on cylinder head cover, side 4-6.
Note: The sender is removed from and fitted onto the underside of the engine, therefore the direction of rotation must be observed.