911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-633003.png)
8. Mark the connection leads to the relevant fuse element.
9. Unscrew the fastening nuts -1-, remove the washer -2- and take out the fuse element -3-.
10. Unscrew fastening nut for the B+ line and remove the power distributor.
Installing power distributor
Installing the current distributor
1. Position the fuse elements -3- in the power distributor in accordance with the wiring diagram and position the marked connection leads in turn, fit
the washer -2- and tighten with the fastening nuts -1-. Tightening torque: 6 ftlb. Tightening torque: 11 ftlb.
2. Position the B+ line on the power distributor and tighten with the fastening screws. Tightening torque: 11 ftlb.
INFORMATION: If a new power distributor needs to be installed or a fuse element replaced, then a new cover for the fuse elements (blue) and a
new seal label (red) must be fitted. The spare parts are summarized in the PET as a package.
3. Insert the blue cover in power distributor and clip in place.
4. Close the power distributor until the lid is felt to engage and seal with the red seal label.
5. Check the plastic seal on the power distributor for damage; replace it if in doubt.
6. Slide the power distributor upwards between the heater/air-conditioning unit and the bulkhead, and engage in the bulkhead.
