911 Carrera Cabriolet (997) F6-3.6L (2007)
7. Remove retainer plate with integrated seal -1- from the valve.
Note:
^
Handle the hydraulic valve with care; do not turn it at the valve tip or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
8. Check the valve body for damage in the sealing area of the retainer plates. If necessary, the valve must be replaced.
9. Pull the oil strainer with bar magnet out of the cylinder head bore. Clean using solvent naphtha, check for damage and soiling, replace if necessary.
Pay attention to the installation position.
Installing hydraulic valve for camshaft timing
Installing hydraulic valve for camshaft timing
1. Fit cleaned or new oil strainer with bar magnet into the cylinder bore -1-. Pay attention to the installation position.