porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Restraints - Air Bag Lamp ON/Multiple Codes Set|Page 171 > < Engine Control Module|Flow of Diagnosis|Page 161
Page 1
background image

Air Bag Control Module: All Technical Service Bulletins
Restraints - Air Bag Lamp ON/Multiple Codes Set

4/05 ENU  6953

Diagnostic Trouble Codes in Airbag Control Unit

Note:

This Technical Information replaces the TI dated February 2, 2006.

Changes/additions compared to the previous Technical Information:

--> Page 2: Fault codes 80E9/80E 1/8024/801 C/8030/8028: Part numbers for wire harness for airbag in backrest changed or added.

--> Pages 5 and 7: Part number for head airbag wire harness in section --> Technical Information '1

Replacing airbag wire harness on driver's side' and --> Technical Information '2 Replacing airbag wire harness on passenger's side' changed or added.

Vehicle Type:
911 Carrera (997)/911 Carrera S (997)

Model Year:
As of 2005

Concerns:
Airbag control unit

Situation:

-

Airbag warning light activated in multi4unction display,

-

Fault codes (8023,8024,8027,8028, 8030,8034,8049, 801A, 801B, 801C, 80E1, 80E0, 80E2, 80E8 or 8OBA) in fault memory of airbag control unit,

-

Return of functional airbag control units to the Warranty Test Center.

We have received airbag control units that were replaced because of fault codes in the airbag fault memory.

Evaluation of the reported fault codes has shown that airbag control units were replaced even though the airbag control unit was not responsible for
activating the airbag warning light. We also have reason to assume that troubleshooting was not always done in accordance with "Guided Fault Finding"
using the PIWIS Tester.

Note

As a rule, you must carry out "Guided Fault Finding" using the PIWIS Tester in order to support diagnosis and for eliminating faults.

Below, we have provided an overview of the fault codes that may be stored in the fault memory of the airbag control unit as well as relevant information
on possible causes and remedial action.

An airbag control unit with modified software has been installed since 25 January 2005 (911 Coupe': --> 997.618.217.07 and 911 Cabriolet: -->
997.618.219.07). Because of this software update, some of the fault codes listed below are no longer relevant.

Introduction Date:
January 25, 2005

Parts Info:

997.618.217.07 -->  New/Airbag control unit (Coupe)
997.618.219.07 --> New/Airbag control unit (Cabriolet)

Restraints - Air Bag Lamp ON/Multiple Codes Set|Page 171 > < Engine Control Module|Flow of Diagnosis|Page 161