911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-35001.png)
Control Module: Service and Repair
WM 373019 Removing and installing the Tiptronic control unit
Preliminary work
Preliminary work for Tiptronic control module (also referred to generally as control unit below)
Remove right front seat.
Remove rear side trim panel on the right.
Remove right scuff plate.
General warning notes
General warning notes for control units
Warning
Sudden voltage interruption of the power supply to the control module.
^
Destruction of the control module.
--> During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery charger with a
current rating of at least 40 A to the vehicle battery.
--> Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
Removing Tiptronic control unit
Removing Tiptronic control module (also referred to generally as control unit below)
Warning
Sudden voltage interruption of the power supply to the control module.
^
Destruction of the control module.
