911 Carrera Cabriolet (997) F6-3.6L (2007)
NOTE:
-
After the seat-belt pretensioners have been triggered, they must be replaced. The fault can be read out using the PIWIS Tester P 9718. Observe
direction of travel.
-
If the seat-belt pretensioner has been triggered, cut through the belt strap before removing the seat-belt pretensioner. This ensures that the
defective automatic belt device is not installed again.
-
It is important to make sure that the negative terminal of the battery is disconnected.
1. Unscrew fastening screw -1- and remove deflector by pulling it upwards -2-.
2. Pull belt -1- to the front.
3. Using a screwdriver, release the lock for the electric connector -2- on the seat-belt pretensioner in -direction of arrow-.
4. Pull off connector on seat-belt pretensioner -arrow A-.
5. Unscrew fastening screw -arrow B- and remove seat-belt pretensioner.