911 Carrera Cabriolet (997) F6-3.6L (2007)
3. Disconnect wire harness from the connector socket.
3.1. Remove tie-wrap -2- on the connector socket -1-.
3.2. Release single connectors -3- (-arrows A-) and remove them from the connector socket -1- (-arrow B-).
4. Remove front belt lock.
4.1. Unscrew fastening screw -1-.
4.2. Pull front belt lock -2- out through the opening on the seat shell -arrow A-.
4.3. Pull wire harness -3- out through the seat frame -arrow B-.
Installing front belt lock
DANGER: Loosen the safety-related threaded joint.
-
Danger of injury if belt lock is not screwed on correctly.
-
Always replace fastening screw on belt lock after customer service and reworking.
-
Never make alterations to the micro-self-locking screws (e.g. never use lubricant, loosen bolts, and screw them down again).
1. Install front belt lock.