911 Carrera Cabriolet (997) F6-3.6L (2007)
1. Install left and right support.
1.1. Position the support and engage in lower side member.
1.2. Press in the locating peg -1- of the support and check it is seated correctly.
1.3. Tighten the fastening nut -3- and fastening screws -2-. Tightening torque: 7.2 Nm (5.5 ftlb.)
2. Lay the floor covering over the support and engage.
INFORMATION: Ensure that belt strap can run properly.
3. Fasten seat belt mount at left and right.
3.1. Tighten fastening screw -2-, seat belt with fitting -3- and spacer sleeve -4- on inner lower side member. Tightening torque: 50 Nm (37 ftlb.)
3.2. Press in -1- cap.
Installing front main wire harness