911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-613006.png)
18. Disconnect plug connection for rear wheel sensor -25- at left and right.
18.1. Release the cable retainer -arrow A- and pull off the two connectors -arrow B-.
18.2. Unscrew the fastening nut and remove the connector socket -arrow C-.
18.3. Remove rubber sleeve -30-.
19. Pull off connector on rear antenna for tyre pressure monitoring system -26- at left and right.
19.1. Unclip tie-wrap -31-.
19.2. Release and pull off connector on rear antenna for tyre pressure monitoring system -26- at left and right.
19.3. Remove rubber sleeve -30-.
20. Screw off B+ lead -27- on transmission.
21. Release and pull off connector on reversing light switch -28-.
22. Pull rear wire harness out of the engine compartment through the opening in the rear wall into the interior of the vehicle and remove it.
Removing wire harness for auxiliary stop light (Cabriolet)
1. Loosen wire harness for auxiliary stop light on convertible top compartment lid and remove rubber sleeve -2-.
1.1. Remove wire harness for auxiliary stop light on holder from convertible top compartment lid -arrow A-.
1.2. Remove rubber sleeve of wire harness for auxiliary stop light on convertible top compartment lid -arrow B- and pull out wire harness for
auxiliary stop light downward from the convertible top compartment lid.
