911 Carrera Cabriolet (997) F6-3.6L (2007)
2. Install mounting saddle for rear-seat backrest.
2.1. Position mounting saddle for rear-seat backrest -2- and secure with the two fastening screws -1-. Tightening torque: 10 Nm (7.5 ftlb.)
3. Install left and right support.
3.1. Position the support and engage in lower side member.
3.2. Push in the locating peg -1- of the support and check that it is seated correctly.
3.3. Tighten the fastening nuts -3- and fastening screws -2-. Tightening torque: 7.2 Nm (5.5 ftlb.)
4. Lay the floor covering over the support and engage.
INFORMATION: Ensure that belt strap can run properly
5. Secure seat belt mount at left and right.
5.1. Screw in fastening screw -2-, seat belt and fitting -3- and spacer sleeve -4- on inner lower side member. Tightening torque: 50 Nm (37 ftlb.)
5.2. Press in cap -1-.