911 Carrera Cabriolet (997) F6-3.6L (2007)
Differential Output Shaft: Service and Repair
Removing and Installing Left Halfshaft Flange
WM 392519 Removing and installing left halfshaft flange
Preliminary work
Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove the underbody panel.
Removing halfshaft flange
Removing halfshaft flange
Note
Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).
1. Remove drive shaft on transmission side. To do this, unscrew the six hexagon socket head bolts joining the drive shaft and halfshaft flange.
2. Lever out halfshaft flange.
Installing halfshaft flange
Installing halfshaft flange
1. Insert halfshaft flange fully into the transmission.
2. Fit drive shaft on transmission side. To do this, screw in the six Allen screws joining drive shaft and transmission flange and tighten screws.