911 Carrera S (997) F6-3.8L (2005)
4. Lift up buttons (two or three, depending on the vehicle type) and pull them out of the remote control housing.
Assembling remote control
INFORMATION: In the event of a complaint (remote control buttons too easily pressed), the silicone pad and buttons can be replaced with
modified spare parts.
1. Engage new buttons in the remote control housing.
INFORMATION:
-
The PCB should only be held carefully at the edge.
-
Immediately after removal, insert the PCB back into the silicone pad and assemble the remote control.
2. Insert PCB -2- into the new silicone pad -1-.
3. Insert silicone pad -1- with PCB into the remote control housing.