911 Carrera S Cabriolet (997) F6-3.8L (2007)
/f6-3.8l/Page-404005.png)
1. Before fitting the brake pads, check the brake discs for wear.
2. If necessary, push the brake pistons back into their original position using the brake piston resetting fixture NR.144.
3. Insert disc brake pads.
3.1.
If you are using Pagid P40-2 brake pads, insert new damping plates into the pistons. Always remove the protective film on the damping plates
before installation.
Damping plates in brake pistons
3.2.
If you are using the modified brake pads (Pagid P40-3), do not fit any damping plates!
Damping plates no longer used
4. Fit expanding spring, retaining pin -Direction arrow- and new retainer (securing clip) -Arrow- at the top of the retaining pin.
Fit warning contact wire on the brake calipers -Arrow-, disc brake pads and expanding spring.
5. Position disc brake pads by actuating the brake several times.
6. Check brake fluid level and correct if necessary. The brake fluid level must be between the MAX-MIN marking.
