911 Carrera S Cabriolet (997) F6-3.8L (2007)
Fitting piston pin
7.4.
Tap the tool lightly with the ball of your hand, if necessary, while holding the tool firmly in place -1-. Insert pin as far as it will go.
Tapping in piston pin using tool
7.5.
Turn the tool at the rear hexagon -2- in clockwise direction until it pulls easily out of the piston pin without resistance.
Loosening tool 9777 on piston pin
Information
^
Always replace piston-pin circlips following removal.
8. Insert new piston-pin circlip into assembly tool 9776.
8.1.
The large hook -1- on the circlip will have to be at 9 o'clock position later (when engine is vertical).