911 Carrera S Cabriolet (997) F6-3.8L (2007)
4. Close the power distributor until the lid is felt to engage and seal with the red seal label.
5. Check the plastic seal on the power distributor for damage; replace it if in doubt.
6. Slide the power distributor upwards between the heater/air-conditioning unit and the bulkhead, and engage in the bulkhead.
7. Screw down power distributor with the two fastening screws -2-. - Tightening torque: 11 ftlb.
8. Push the B+ of the battery onto the mounting point as far as the stop. Check that the B+ line sits firmly.
Subsequent work
Subsequent work for power distributor
Connect the battery and carry out "Work instructions after disconnecting the battery".