911 Carrera S Cabriolet (997) F6-3.8L (2007)
/f6-3.8l/Page-546007.png)
Supporting mount assembly
6. Place spring strut supporting mount assembly onto the piston rod so that the end of the coil spring is located inside the spring plate.
7. Fit stop plate in the correct position (domed side upwards) and screw a new fastening nut onto the piston rod. Important: For PASM spring struts,
place the lug of the stop plate (in area of spring strut mount) in the groove of the piston rod (twist lock of piston rod opposite the supporting
mount). Make sure that the plastic part of the bearing sits correctly in the recess of the supporting mount -arrows-.
Supporting mount (correct seat)
8. On PASM spring struts, before tightening the lock nut, align the stop plate -2- offset 45° from direction of travel marking -Arrows A- of the
supporting mount.
Stop plate position (PASM only)
The value: 45° + - 2° is necessary so that the two grooves of the stop plate (cut-outs for countering) are positioned over or between the recesses
(pockets in the rubber part) which lie below.
9. Tighten fastening nut to the specified tightening torque. For PASM spring struts, counter at the stop plate using retaining tool P 9630/1. For
conventional spring struts, counter at the hexagon socket of the piston rod using special tool P 9630.
