911 Carrera S Coupe F6-3.6L SOHC (1998)
Downshift Switch: Adjustments
Prerequisites:
-
The idle position of the accelerator cable must be correctly adjusted.
-
Kickdown switch in installation position.
Procedure
1. Connect system tester 9288.
2. Unhook pushrod from accelerator pedal.
3. Switch on system tester and select throttle valve in DIVIE /actual values menu.
4. With the pushrod unhooked, push the accelerator pedal down to the stop (throttle valve open up to stop) and read throttle position 1 off on system
tester.
NOTE: With the throttle valve open (accelerator pedal fully depressed), the position is 84°±30°.
5. Hook pushrod back onto accelerator pedal.
6. Push gas pedal down as far as possible without operating kickdown switch and read off throttle position 2 on system tester. The position indicated
must be 30 less than position 1 (tolerance ± 10).
NOTE:
-
If the angle is too large, set the pushrod to a shorter position.
-
If the angle is too small, set the pushrod to a longer position.
-
After resetting the length of the pushrod, check the angle. It must not be smaller than 79°.