911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
Remove the holding bracket for the door seal formed piece on the inside (if installed).
-
Remove the 4 bolts from the door seal bracket on the roof frame.
Pull the seal off in the area of the "A" pillar.
Remove the sealing material from the bottom of the seal and seal base.
-
Install a clamp (part number 999 507 542 01, arrow 1, figure 2) onto the plastic hose of the windshield frame seal. This prevents the plastic drain
hose from moving to the top when installing the door seal.
-
Install a 2 mm wide strip of sealing butyl around the metal drain pipe (arrow 2, figure 2) of the roof frame.
-
Lay butyl material on top of the formed piece on the door seal (arrows A and B, figure 3).
-
Reinstall the door seal. Ensure that the water drain pipe is properly installed in the opening of the door seal and the butyl seals are not moved.
-
Secure the door seal onto the roof frame with the bracket.
-
Reinstall the holding bracket (part number 993 562 571 00, (arrow, figure 4) for the door seal on the inside.
