911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
Remove the wind deflector.
Repair:
-
Open the sliding roof completely.
-
Position the fold-up lever for the wind deflector to the rear using special tool 9587 (See Figure 18).
-
Use the appropriate 9587 tool (left or right) for the side of the vehicle being repaired (Figure 19). Insert the tool into the guide rail channel behind the
cable driver. Use a screwdriver to push the tool 9587 into the cable driver which will allow the cable driver to move forward. This will cause the
fold-up lever to move down toward the rear. Leave the tool in place while repairs are being made.
Caution:
Do not close the glass roof while the tool 9587 is installed.
-
Pull out the rubber side seal.
-
Begin to remove the trim strip starting at the front and working toward the rear (Figure 19). If necessary, use a piece of hardwood covered with
leather and light hammer taps to dislodge the strip.
-
After the trim strip is completely removed, clean the body flange thoroughly and remove any foreign material or existing teflon strips.
