911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
Install rubber roof seal, the seal must be approx. 1 mm longer in the front and rear (Figure 28, pos.1)
-
Apply glue to the inside of the roof rail trim strip (Figure 28, pos. 2). Apply glue approx. 1 mm thick onto the body (Figure 28, pos. 2A - arrow).
-
Apply glue approx. 2 mm thick on the back side of the roof trim strip (Figure 28, pos. 3)
-
Start the installation of the roof rail strip at the lower corner of the rear window. Light taps with a hammer and leather covered hardwood block may
be necessary to fully seat the trim strip along its entire length. (Figure 28, pos. 4)
-
Remove excessive glue
Caution:
The roof rail trim strip must only be cleaned with mild soap and water.
-
Move the special tool 9587 (left and right) with a screw driver to the rear and remove out of the slot (Figure 28, pos. 5).