911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
If necessary, provide clearance for the metal frame to the glass using a plastic wedge (Figure 19 arrow). Be very careful not to damage the rear
window, primer border or sealing profile. A gap of 2.0 mm is required.
-
Carefully press the plastic wedge between the inner window frame and the rear glass as shown in figure 19. Check the entire window frame for
adequate clearance to the rear window. If it is not possible to gain clearance using the plastic wedge (inside metal frame keeps returning to original
position) use cable ties cut into small lengths to act as spacers between the rear glass and frame.
Area #6
6.1
Creaking noises in the area of the rear cover and window.
Possible cause:
The edge of the rear wall trim panel touches the rear glass, C pillar covers or side covers.
Repairs:
6.1
Creaking noises in the area of the rear cover and window.
-
Install a length of felt material, part number, 993 555 545 00 onto the edge of the rear wall trim panel (Figure 20). As of October 12, '95 vehicles
with leather covered rear wall trim panels have the felt strip installed in production.
Area #7
7.0
Creaking or rattle noises in the area of the left or right inner roof rail trim panels.
Possible causes:
7.1
The roof trim panel touches the metal roof frame (left or right).
7.2
The center securing support for the roof trim panel is loose (left or right).
7.3
Play in the front or rear securing elements (left or right).
7.3
The windshield frame cover touches the screw heads.
Repairs:
7.1
The roof trim panel touches the metal roof frame (left or right).
