911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
Use the appropriate 9587 tool (left or right) for the side of the vehicle being repaired (Figure 27, pos. 1). Insert the tool into the guide rail channel
behind the cable driver. Use a screwdriver to push the tool 9587 into the cable driver which will allow the cable driver to move forward. This will
cause the fold-up lever to move down toward the rear. Leave the tool in place while repairs are being made.
Caution:
Do not close the glass roof while the tool 9587 is installed.
-
Pull out the rubber roof seal, starting at front (Figure 27, pos.2).
-
Remove the roof trim strip, starting at the front (Figure 27, pos.3). If necessary use a piece of hardwood covered with leather and light hammer taps
to dislodge the strip.
-
Remove the roof trim strip in the rear. Use a piece of hardwood covered with leather and light hammer taps, starting at the rear (Figure 27, pos. 4).
-
After the trim strip is completely removed, clean the body flange thoroughly and remove any foreign material or existing teflon strip (Figure 27, pos.
5).
Notes on roof trim strip installation.