911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
NOTE: During service procedures, refer to the illustrations above and the information below
1. Install snap ring
-
Place new snap ring manually into tapered assembly sleeve 9500/2
2. Engage snap ring
-
Using assembly tool 9500/3, push snap ring down until the snap ring engages audibly into the groove of the assembly sleeve 9500/2.
CAUTION: Make sure the snap ring is preassembled with the tapered assembly sleeve on a solid support but only immediately before fitting
the assembly to the piston pin bore.
3. Visual check
-
Remove assembly tool 9500/3 and visually check snap ring for correct seating in the groove of the tapered assembly sleeve 9500/2.
CAUTION:
-
The snap ring may pop out of the assembly sleeve
-
Be careful to avoid injury!
4. Preassemble pistons to cylinders
-
Preassemble pistons and cylinders on a plastic or wooden support (to protect the cylinder) off the engine.