911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
1.
Set selector shaft to position "N" (turn shaft anti-clockwise up to the stop and then back two clicks) and place switch in the correct position.
2. Adjusting multifunctional switch.
-
Push pointer of special tool 9326 onto the selector shaft and turn the switch until the locating pin can be pushed into the fixing hole of the
switch.
-
Tighten the mounting screws to 10 Nm (7 ft lb) in this position.
3. Check, and if necessary adjust, setting of selector lever cable. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift
Linkage/Shift Cable