911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
Transmission Position Switch/Sensor: Service and Repair
Removal
1. Set selector lever to position "N".
2. Remove transmission undertray.
3. Remove rear underside panel.
4. Remove left rear hot air pipe.
5. Disconnect selector lever cable from actuating lever.
6. Remove actuating lever.
7. Press retaining lugs for wire retainer "A" together and lift holder out upwards.
8. Detach, unlock and disconnect connector.
9. Unscrew fastening screws for multifunctional switch completely and remove switch.
Installation
For installation, proceed in reverse order.
Tightening torques:
-
Multi-functional switch to transmission: 10 Nm
-
Actuating lever to selector shaft: 15 Nm