911 Targa 4S (997) F6-3.8L (2007)
Remove the side panel lining at rear. Refer to Removing and installing rear side panel lining
1. Connect plug of adapter cable 9257/3 to the belt tensioner.
2. Connect ignition device No. 9257 to the 2-pin plug of adapter cable No. 9257/3.
3. Place the ignition device in front of the vehicle through the door gap and trigger it.
Triggering of airbag units
WARNING: Detonation of airbag units.
-
Danger of injury from emerging objects, e.g. splinters.
-
Hearing impairment by explosion noises.
-
Danger of burns from hot airbag units.
-
Danger of poisoning by emerging gases.
-
Observe a safety distance of at least 10 m.
-
Wear hearing protection.
-
Each airbag unit, the respective ignition stages 1 and 2, and each belt tensioner must be triggered individually.
-
Allow airbag units to cool down for the appropriate time.
-
Open the vehicle doors to allow the gases to escape.
Connect the ignition device to a separate battery and press the button.