911 Turbo AWD (996) F6-3.6L Turbo (2001)
Brake Fluid Pump: Service and Repair
Remove and Install Booster Pump For PSM
Removal
NOTE: The booster pump -1- is removed with the holder -1a-.
1. Switch off ignition.
2. Remove cover -A- from the hydraulic unit.
3. For the removal of the booster pump, carry out the following removal steps:
-
Remove suction line -2- for booster pump. Undo pressure pipe on the booster pump -3-. Close the lines and the pump connections with
suitable plugs.
-
Release plug -4- -arrows- and disconnect. Remove connector housing rearwards from out of the bracket -moving arrow-.
-
Undo the three plastic fastening nuts -5- and remove the booster pump -1- with the holder -1a-.
Installation
1. Install in reverse order.
2. Bleed the brakes.
NOTE:
-
First bleed brakes as usual.
-
Do not carry out booster pump activation with the Porsche System Tester 2 until after this has been done (after conventional bleeding) as