911 Turbo AWD (996) F6-3.6L Turbo (2001)
1. Insert filter element. Insert the filter element into the cleaned air cleaner housing. Retighten the two air cleaner housing halves with the new captive
screws.
2. Clip in hot film mass air flow meter. To do this, insert the cable into the omega clip on the left air cleaner housing side and then close the clip.
3. Place the air cleaner housing in the engine compartment as shown and move into installation position. To do this, first turn the housing to the right
by approx. 90 ° and push the rubber hose over the flange. Then swivel downwards by 90 °.
4. Tighten the fastening screw M6x34 to 10 Nm (7.5 ft.lbs).
5. Tighten the hose clamp on the connecting hose. Reconnect the plug on the hot film mass air flow meter. The plug must engage audibly.