porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Body - Rear Spoiler Malfunctions|Page 188 > < Body - Rear Spoiler Malfunctions|Page 186
Page 5
background image

4

Rear spoiler extends and/or retracts unevenly.

Remedial action

4.1

Switch on ignition.

4.2

Extend and then retract the rear spoiler manually using the rocker switch in the dashboard trim panel, see Owner's Manual, chapter entitled
"Controls, Safety, Instruments - Extending rear spoiler". While doing this, get a second person to observe the extending/retracting action of the
rear spoiler.

--> Rear spoiler extends and/or retracts unevenly.

Possible causes of fault:

^

The pipes in the hydraulic cylinders are dirty and as a result, cannot move freely.

^

The rear spoiler drive was installed too tightly.

^

The rear spoiler drive is defective.

4.3

Pipes in the hydraulic cylinders are dirty.

4.3.1 Extend the rear spoiler manually. To do this, press the rocker switch in the dashboard trim panel, see Owner's Manual, chapter entitled "Controls,

Safety, Instruments - Extending rear spoiler".

4.3.2 With the rear spoiler extended, clean dirty pipes in the hydraulic cylinders with a suitable cleaning agent (e.g. insect remover), then wash them

with a sponge and clean water and dry them off with a cloth.

4.3.3 Check the function of the rear spoiler drive. To do this, extend, retract and then extend the rear spoiler again manually using the rocker switch in

the dashboard trim panel.

--> Rear spoiler extends and retracts evenly on both sides --> Continue with Step 4.6.4.

--> Rear spoiler extends or retracts unevenly --> Continue with Step 4.4.

4.4

Rear spoiler drive was installed too tightly.

4.4.1 Retract the rear spoiler manually - if it is extended. To do this, press and hold down the right half of the rocker switch in the dashboard trim panel

until the rear spoiler is retracted.

4.4.2 Open the engine compartment lid, loosen the screws on the affected hydraulic cylinder ( Figure 7-Item A or Item B-) and correct the installation

position by moving the hydraulic cylinder sideways. Then tighten the hydraulic cylinder again. Tightening torque 10 (7.5 ftlb.) Nm.

4.4.3 Close the engine compartment lid and check the function of the rear spoiler drive. To do this, extend and then retract the rear spoiler manually

using the rocker switch in the dashboard trim panel.

--> Rear spoiler extends and retracts properly --> Continue with Step 4.6.4.

Body - Rear Spoiler Malfunctions|Page 188 > < Body - Rear Spoiler Malfunctions|Page 186