911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
b. Fold the convertible-top material around the roof frame edge without wrinkles. The convertible-top covering is initially held with fixing clips.
7. Fastening the retaining rail and convertible-top seal on the roof frame 1
a. Remove the fixing clips.
b. Insert convertible top seal -12- at the front corners into roof frame 1 in -direction of arrow- and tighten with torx screws T25 -11-.
Tightening torque: 1.7 Nm (1.5 ftlb).
c. Position the retaining rail -10- on roof frame 1 and tighten using T25 Torx screws -9-.
Tightening torque: 3.5 Nm (2.5 ftlb.)
8. Fastening seals and retaining strip at the sides of the roof frame
The seal on the roof frame at the sides consists of two parts.
a. Position the upper seal -6- onto the retaining strip -7- in -direction of arrow A- and screw on to roof frame with the Torx screws T15 -8-.
Tightening torque: 2.8 Nm (2.0 ftlb.)
b. Press the lower seal -5- into the profile of the retaining strip -7-.
9. Fastening tension cable of the convertible-top covering
Position the tension cable eyelet -3- on the main bow and fasten with the T25 -4- Torx screw.
Tightening torque: 7 Nm (5 ftlb.)