911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
a. Pull the tightening strip of the convertible-top covering -16- from the groove of the main bow -17-. Remove convertible-top covering from the
vehicle.
Installing the convertible-top covering
All pins and screw joints must be checked for tightness before the convertible-top covering is installed.
The tension strap and the bracing strap must be replaced before fitting the convertible-top covering.
The rear glass window must be installed before fitting the convertible-top covering.
1. Fastening convertible-top covering at the main bow
Lay the convertible-top covering on the convertible-top frame, fit the front tightening strip -16- of the convertible-top covering in the groove of the
main bow -17- and centre.
2. Fitting convertible-top covering at the corner bow
a. Press tightening strip centre (notch marking) into groove of the corner bow (centre of the corner bow is identified by a hole).
The tightening strip is secured by tapping in the seal -arrow B-.
b. Coat the cloth covering with adhesive and stick it inside around the corner bow -inset A-.
3. Fastening holding strap of the convertible-top covering
a. Position holding strap at the right on convertible-top frame 3 on the inside and press in the clip.
On the left side, the holding strap is fastened with the fastening clip of the wiring harness.