911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
10. Fastening convertible-top covering on the tension bow
NOTE: Cut-outs have been integrated to the right and left of the additional seal.
a. Integrate the additional seal parallel to the tension strap -C- into the cut-outs on the right and left using a knife.
b. Press tightening strip centre (notch marking) -inset A- into the lower groove of the tension bow -inset B- (centre of the tension bow is
identified by a hole) -inset A-.
c. The reference overlap seams of the convertible-top covering must be positioned and centred in the additional seal -arrow Ccut- outs on the left
and right.
d. Secure the convertible-top covering by tapping in the seal -inset D-.
11. Fitting tension bow seal
a. Press tension bow seal into the lower groove of the tension bow and fasten at both ends with the T25 Torx screws -2-.
Tightening torque: 5 Nm (3.5 ftlb.).
12. Fastening pull strap at the main bow
a. Pull the restraining strap through the fabric pocket on the main bow.
b. Engage both ends of the restraining straps into the tension spring -arrow A-.
c. Position fabric pocket on the main bow and fasten with the T 10 -1- Torx screws.