911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Brake Master Cylinder: Service and Repair
Removal
Removal
Note: The booster pump -1- remains fitted (installed) during removal and installation of the brake master cylinder.
1. Remove cover -A- from the hydraulic unit/brake unit.
2. Remove brake fluid from reservoir using suction.
3. Disconnect the electrical line (plug) on the reservoir.
4. Remove suction line of booster pump -2-.
5. Undo the brake lines on the brake master cylinder. Close the brake lines and the brake line connections with suitable plugs.
Note:
^
-A- = Brake master cylinder fastening nuts
^
-B- = Brake booster fastening screws (Torx)
6. Undo the fastening nuts -A- of the brake master cylinder. Pull out brake master cylinder.