911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
/f6-3.6l_turbo/Page-283006.png)
8. Remove special tool (retaining device) 9624/1.
9. Fasten stabilizer.
Tightening torque: 25 Nm (18 ft. lbs.).
10. Install rear mufflers with new seals. The seals between the exhaust turbochargers and the rear muffler must be replaced. Move the rear muffler into
installation position and push the two tensioning straps over the holder on the engine carrier. Subsequently tighten the two hexagon socket head
bolts slightly.
11. Push the heat shields over the studs of the exhaust turbocharger. Fit new hexagon nuts.
Tightening torque: 30 Nm (22 ft. lbs.).
12. Tighten restraining straps on the rear muffler.
Tightening torque: 15 Nm (11 ft. lbs.).
13. Fit heat shields, bumper and rear spoiler.
14. Install drive belt.
15. Check that the installation position of the drive belt on all drive wheels is correct. Check the installation position on the belt pulley from
underneath (use light source).
16. Install pressure pipe:
