911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
^
The oil guide housing of cylinder 1 - 3 and 4 - 6 differ in height.
12. Remove oil guide housing. Heat the three hexagon socket head bolts using a hot-air gun, unscrew and remove the housing. The fastening screws
are microencapsulated and therefore must be replaced.
13. Remove camshaft bearing cap. To do so, uniformly unscrew the hexagon-head bolts of the relevant bearing covers from the inside. Remove the
bearing covers in the specified order.
14. Remove camshaft bearing covers. Lift the bearing covers up and off. The bearing covers must not be confused.
15. Remove thrust bearing cover. Unscrew the hexagon-head bolts and remove the thrust bearing cover up and off.
16. Lift camshafts up and out.
Installing camshafts
Note:
^
The oil guide housing of cylinder banks 1 - 3 and 4 - 6 differ in height.