911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
1. Remove air cleaner assembly
Remove the complete air cleaner assembly.
a. Undo hexagon-head bolt M6 x 34.
b. Undo the hose clamp on the throttle body.
c. Pull off plug from hot film mass air flow sensor and remove air cleaner assembly.
2. Loosen servo pump wheel
a. Mark belt travel direction with a colored pen.
b. Undo the three -hexagon-head bolts- on the servo pump by approximately. one half turn.
3. Relieve drive belt
Relieve drive belt. To do this, turn the tensioning roller clockwise and simultaneously remove the belt from the drive pulleys.
4. Remove servo pump wheel
Note:
^
Only remove the servo pump wheel when the drive belt is completely relieved!
a. Remove servo pump wheel with drive belt to the rear.
b. Remove the belt from all drive wheels and lift up to remove.