911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
/f6-3.6l_turbo/Page-251010.png)
18. Push the heat shields over the studs of the exhaust turbocharger. Fit new hexagon nuts.
Tightening torque 30 Nm (22 ftlb.).
19. Tighten restraining straps on the rear muffler.
Tightening torque 15 Nm (11.0 ftlb.).
20. Fit heat shields, bumper and rear spoiler.
21. Install bracket for the generator. Replace the four O-rings on the two connecting flanges between the two coolant outlet necks of cylinder bank 1-3.
Then screw in the four fastening screws. Important: The front right screw must be inserted with Loctite 574 (as shown in the illustration).
Tightening torque 65 Nm (48 ftlb.).
22. Check whether locking clips are properly seated.
23. Fit coolant hoses. Always replace O-rings on the coolant hoses. Wet O-rings with plenty of water.
NOTE: Never fit dry; only use water.
24. Push on coolant hose. Align the flange of the coolant hose as shown in the illustration (lug/groove). Press the coolant hose firmly against the
