911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Installing the hydraulic valve
1. Replace O-ring. Replace the O-ring on the hydraulic valve.
2. Press the hydraulic valve into place. Insert the hydraulic valve into the camshaft housing and press it firmly into place. Place the retaining cover in
place.
Pay attention to the cut-out on the fastening arm.
Note:
^
In order to make it easier to position the hydraulic valve, a socket with an extension of wrench size 20 may be used.
3. Position the two fastening screws and screw them in evenly. Tighten screws to 10 Nm (7.5 ft. lbs.)
4. Install the plug coils. Place the adjacent plug coils on the spark plugs again. Tighten the two fastening screws to 10 Nm (7.5 ft. lbs.).
5. Install heat shield. Tighten the two fastening screws to 10 Nm (7.5 ft. lbs.).