911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
/f6-3.6l_turbo/Page-255004.png)
6. Reinstall the shield of the exhaust system. Tighten the two fastening nuts on the side member for this purpose.
7. Install charge air cooler. To do so, place the charge air cooler back in the vehicle.
8. Tighten the front two fastening nuts and the fastening screw in the wheel well, all to 23 Nm (17 ft. lbs.).
9. Tighten the front fastening nut and the fastening screw to 23 Nm (17 ft. lbs.). Supply the two hose connections on the charge air cooler with new
O-rings and fit them in place. The connections must audibly engage.
10. Tighten the two sheetmetal nuts on the heat shield.
Fit rear spoiler again.
Location Thread Tightening torque Nm (ft. lbs.)
Heat shield on camshaft cover M6 10 (7.5)
Plug coils....................................................................................................................................................................................................... M6 x 25 10 (7.5)
Fastening screws on the switch-over valve................................................................................................................................................... M6 x 25 10 (7.5)
Fastening screws on the charge air cooler.............................................................................................................................................................. M8 23 (17)
Fastening nuts on the charge air cooler.................................................................................................................................................................. M8 23 (17)
