911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Heater Core: Procedures
Removing And Installing Heat Exchanger
Removing heat exchanger
1. Remove the covers over the heating/air-conditioning system, battery and fluid tank.
2. Disconnect the battery and cover terminal or battery.
3. Remove the entire wiper link with wiper motor. Refer to No. 921519, Removing and installing wiper motor.
4. Loosen right dome strut and bracket at the cowl frame and remove -(arrows)-.
5. Clamp shut both heater hoses in front of the heat exchanger with a commercially available hose clamp. Loosen heater hoses on the heat exchanger
and pull off -(arrows)-.
6. Carefully remove cover over the heat exchanger.
7. Release heat exchanger -(arrows)- and pull it up and out.
Installing heat exchanger
1. Seal cover over the heat exchanger airtight with butyl adhesive.