911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Housing Assembly HVAC: Procedures
Removing And Installing The Heating/air-conditioning Unit
Removing heating/air-conditioning unit
1. Remove the covers over the heating/air-conditioning system, battery and fluid tank.
2. Disconnect and remove the battery.
3. Remove the refrigerant by suction using the service unit.
4. Detach the air-conditioning lines at the expansion valve. Immediately close connections and lines with plugs so that they are air-tight.
WARNING: Danger of injury if airbag units are triggered while ignition key is not removed:
-
Always remove ignition key during body work, and do not commence work until a waiting period of at least 1 minute has elapsed.
5. Remove steering wheel and loosen steering-column panel.
6. Undo the -central screw (clamp)- on the steering column switch from below and pull it forwards slightly. Remove the cover at the top and
disconnect the electrical plug connections. Remove the steering column witch.
7. Loosen instrument panel and unclip right side upwards.