911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
/f6-3.6l_turbo/Page-391002.png)
9. Disconnect the connector of the overrun air valve module -arrow- and pull off the two vacuum hoses -arrow-.
10. Undo the hose clamp on the left pressure pipe and remove the entire overrun air valve module -Figure-.
11. Pull the vent line off the coolant expansion tank.
12. Remove fuel filter.
13. Loosen and unscrew the three fastening screws -arrows- at the front intake pipe connector.
14. Remove hose clamp and pull off ventilation hose from the intake pipe.
15. Undo the upper fastening screw -right arrow-. Lift the intake pipe out of the shaft bolt -left arrow- and remove towards the rear of the vehicle.
Remove the seal.
16. Disconnect the activated carbon filter lead. To do so, disconnect the coupling -arrow-.
17. Pull off the connector -1- of the camshaft adjustment valve.
NOTE: With all fuel lines, always counter with a second open-ended wrench:
