911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Intake Air Plenum: Service and Repair
Removing and Installing Intake Distributor - Engine Removed
Removing And Installing Intake Distributor - Engine Removed
NOTE:
-
Pay attention to the routing of the vacuum hoses.
-
Pay attention to the storage of the individual parts.
1. Remove the secondary air pump.
2. Undo the throttle body connections.
3. Undo the 2 spring band clamps and the screw-type hose clamp -arrows- and pull off the hoses.
4. Unclip the vacuum line -arrow- on the strain relief strut.
5. Pull the three vacuum hoses -arrows- off the intake distributor.
6. Undo the holder of the fuel return line. Unscrew the M6 screw -arrow- for this purpose.
7. Connect the connector of the overrun air valve -arrow- and pull off the two vacuum hoses -arrow-.
8. Remove the overrun air valve module.
9. Remove the activated carbon filter lead. To do so, disconnect the plug connection on the bleeder valve -arrow- and disconnect the coupling on the
pressure pipe.