911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
/f6-3.6l_turbo/Page-402001.png)
Intake Air Plenum: Service and Repair
Disassembling and Assembling Intake Distributor
Disassembling And Assembling Intake Distributor
Disassembling the intake distributor
1. Unscrew screws no. 8 and no. 10 and remove the strain relief.
2. In each case, undo the two hose clamps on the left and right of the distributor pipe and push the rubber sleeves as far as possible on to the
distributor pipe. Then remove the distributor pipe.
3. Open the two hose clamps on the closure caps with strut and remove the strut.
4. Disconnect the vacuum lines.
Vacuum lines
