911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Engine Control Module: Service and Repair
Removing And Installing DME Control Module
NOTE:
-
If the DME control module is replaced, it must be programmed using the Porsche System Tester. Thus, the DME control module can be adapted to
the vehicle, the national variant and the equipment. The DME control module is located behind the right rear seat.
-
If possible, before the DME control module is removed and replaced, a read-out of the vehicle data should be obtained from the Porsche System
Tester.
-
Symbol for the TAB key = ->|
-
Follow the instructions for the Porsche System Tester.
Removing DME control module
NOTE: Switch ignition off and remove ignition key.
1. Fold the backrests of the rear seats forward.
2. Lift the carpet lining up and remove.
3. Unscrew fastening screw -1- and loosen fixing nut -2-.
4. Turn over the control module holder -3-.
5. Push in connectors -A- -arrow- and pull out.
6. Push in locking element -arrow- of connectors -Band actuate the latching lever -4-.
7. Unscrew 4 fastening screws on the control module holder -3- and remove the control module.
Installing the DME control module
1. Fasten the control module on the control module holder with the four fastening screws. Tightening torque: 10 Nm (7.5 ftlb.).