911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Installing knock sensor, cylinder bank 4 - 6
1. Clean contact surface for the sensor on the engine block.
NOTE: In order to guarantee the proper function of the knock sensor, always use the correct tightening torque.
2. Position the knock sensor, then screw in and tighten the M8 hexagon-head bolt -upper arrow- with the correct tightening torque.
Tightening torque: 23 Nm (17 ftlb.)
3. Insert plug -lower arrow- of the knock sensor.
4. Install the crankcase ventilation tube. For this purpose, place the crankcase ventilation tube with the union nut -arrow- in position, but do not
tighten yet.
NOTE: Always replace the flange seal of the crankcase ventilation tube:
5. Replace the flange seal; then place the two M6 screws -arrows- in position and tighten.
Tightening torque for hexagon-head bolts 10 Nm (7.5 ftlb.)
6. Tighten the union nut -arrow- with the correct tightening torque.
Tightening torque 30 Nm (22 ftlb.)
7. Install the oil container.