911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Yaw Rate Sensor: Removal and Replacement
Removing and installing rate-of-turn sensor
Two versions of the rate-of-turn sensor have been installed for the PSM (Porsche Stability Management) system in the 911 Turbo (996) since series
introduction of this vehicle. The first version -A- with part number 996.606.147.00 and the new/current version -B- with part number 996.606.145.00.
Information:
^
The transverse acceleration sensor is integrated in the rate-of-turn sensor.
^
First version of the rate-of-turn sensor with part number 996.606.147.00. will no longer be available after existing supplies are used up.
^
The new/current rate-of-turn sensor 996.606.145.00 (introduction shortly before the end of model year 2000) can be retrofitted instead of the first
version 996.606.147.00. In case of first-time installation, various parts must be replaced in the surrounding area and some parts are omitted.
Removal
Caution: The rate-of-turn sensor is a micro-mechanical component and is very sensitive to impacts!
Information:
^
Perform removal and installation with the ignition switched off!