911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
1. Move the front seats into the rear seat position.
2. Remove side-panel lining in front of the center console on the left -A- and right.
3. Remove fastening nuts of the rate-of-turn sensor on the right -arrow- and left.
4. Pull out the rate-of-turn sensor and unlock and pull off the plug with the ignition switched off.
Information:
^
Pull at the plug housing only! Never pull the electrical connections!
Installation
1. Install in reverse order.
2. After installing the rate-of-turn sensor, read out the PSM fault memory with the Porsche System Tester 2 and erase. Carry out a static test. Then
start the engine. The PSM-related lights in the instrument cluster must go out when the engine is running. Read out the PSM fault memory again.
There must not be any stored faults.