911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
7. Remove oil temperature sensor.
8. Remove plug (wrench size 19). Undo oil pressure sender. Important: always counter with a second wrench (wrench size 22) when doing so. Pull
off the electrical plug and unscrew the sender.
Installation
1. Fasten sender with new sealing ring. Counter with a second wrench when doing this. Push on the electrical plug.
Sender tightening torque: 30 Nm (22 ft. lbs.)
2. Install oil temperature sensor with new sealing ring.
3. Check throttle sealing ring and replace it if necessary. Fasten throttle body. Push on the electrical plug.
4. Install pressure pipe. Wet the connecting hoses between the charge air coolers and pressure pipe with water at the connecting points and fit the
hoses. The hoses must audibly engage. Then recheck whether they are positioned properly by tilting and pulling on them.
Location...................................................................................................................................................................... Thread Tightening torque Nm (ft. lbs.)
Oil pressure sender....................................................................................................................................................................................................... 30 (22)