911 Turbo Cabriolet (996) F6-3.6L Turbo (2004)
Cabin Temperature Sensor / Switch: Removal and Replacement
Removing and Installing Interior Temperature Sensor
Removing And Installing Interior Temperature Sensor
Removing interior temperature sensor
1. Pull off cover for temperature sensor.
2. Undo three Torx screws of the right side vent and carefully pull the side vent out of the dashboard. One Torx screw is located behind the cover.
3. Press locking tabs together slightly and remove temperature sensor from the dashboard.
4. Pull off electrical plug connection.
Installing interior temperature sensor
1. Engage electrical plug connection, ensuring that the temperature sensor is seated properly in the dashboard.
2. The cover simultaneously serves as the intake grille for the fan and must not be closed off.
Removing and Installing Footwell Blower Outlet Sensor
Removing And Installing Footwell Blower Outlet Sensor
Removing footwell blower outlet sensor
1. Remove footwell bulkhead.
2. Unclip centre console cover at the front and remove the footwell vent (3 screws).
3. Turn blower outlet sensor by -90 degrees- and pull it out.
4. Pull electrical plug connection off blower outlet sensor.
Installing footwell blower outlet sensor
1. Position temperature sensor on the heating/air-conditioning unit housing and turn by 90 degrees (tighten).
2. Engage electrical plug connection and route wire carefully.